Allen-Bradley 1770-M10 Manual de Instalação descarregar pdf (Página 33)

System Start-Up

Chapter 4

44

3. Select position 1 of the POWER switch. The POWER indicator lights

green; if it does not, refer to chapter 5 for troubleshooting aids.

Refer to the Advisor2 Installation and Start-up Guide, publication 6171-6.7.2

for information on creating a database.

Before you begin operations, you will need to know about the operating

system program. The 1770-M11 system needs the software of the operating

system program to communicate to the peripheral communication module. This

operating system program is located in two places:

within the hard disk unit

packaged on the micro-floppy labeled, Operating System for PLC-3

Peripheral Communication Module/Mass Storage System (Series B, Revision

A).

To load the program from the Winchester hard disk unit onto the DMIM, follow

these steps (Figure 1.17). Make sure the POWER switch is at position O.

System Startup Procedure for

the 1770M11 System

How to Load the Operating

System Program from the Hard

Disk

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 74 75

Sem comentários

Allen-Bradley 1770-M10 Manual de Instalação Página 33